You should be able to run 

Mminfo -av -s backupservername -r"client,name,sscreate(30),sscomp(30)"
-q"name=D:\,savetime>=yesterday" -c clientname

This will tell you the start and end time for the drive partition in
question. 


EDWARD COTY
LEAD STORAGE ENGINEER, LCNA, NACP
WORK - 973-533-2098
CELL - 973-296-0918
EDWARD.COTY AT AIG DOT COM

-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of Stan Horwitz
Sent: Tuesday, November 13, 2007 10:10 AM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] Using mminfo to get saveset backup time

Greetings everyone;

I am interested in finding out how long each disk drive in particular
Windows client takes to back up.  I have been reading through the mminfo
man page and I don't see anything that helps shed light on that
question. Am I missing something, or is this just not possible? If it is
possible, how?

To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or via RSS at
http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER

To sign off this list, send email to listserv AT listserv.temple DOT edu and 
type "signoff networker" in the body of the email. Please write to 
networker-request AT listserv.temple DOT edu if you have any problems with this 
list. You can access the archives at 
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER