Re: [Networker] NetWorker + Windows SAN Tapes
2006-09-06 12:48:21
That's why I said you also have to configure the FC Bridge/Router on the
Library and enable "device mapping" which in essence maps a SCSI ID to a
FC LUN. I use IBM 4560LX's (aka Neo2000's) and configure this setting on
the FC Router.
Thanks,
Dana
-----Original Message-----
From: Davina Treiber [mailto:DavinaTreiber AT peevro.co DOT uk]
Sent: Wednesday, September 06, 2006 10:06 AM
To: EMC NetWorker discussion; Greggs, Dana
Subject: Re: [Networker] NetWorker + Windows SAN Tapes
Greggs, Dana wrote:
>You have to enable persistent binding. The method varies according to
>the hardware manufacture but you must do it on the HBA and the FC
bridge
>of the tape library.
>
>
Persistent binding is not sufficient to totally solve this problem.
Persistent binding locks down the binding of WWPN or WWNN to SCSI b.t.l
addresses. It does not control the mapping of SCSI addresses to Windows
device names.
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] NetWorker + Windows SAN Tapes, Gaddy
- Re: [Networker] NetWorker + Windows SAN Tapes, Greggs, Dana
- Re: [Networker] NetWorker + Windows SAN Tapes, Greggs, Dana
- Re: [Networker] NetWorker + Windows SAN Tapes, Gaddy
- Re: [Networker] NetWorker + Windows SAN Tapes,
Greggs, Dana <=
- Re: [Networker] NetWorker + Windows SAN Tapes, Brian Narkinsky
- Re: [Networker] NetWorker + Windows SAN Tapes, Brian Narkinsky
- Re: [Networker] NetWorker + Windows SAN Tapes, Gaddy
- Re: [Networker] NetWorker + Windows SAN Tapes, Maarten Boot
- Re: [Networker] NetWorker + Windows SAN Tapes, Dave Mussulman
|
|
|