Re: [Networker] Finding a tape
2006-08-02 11:47:44
Hello,
As somebody tell before, you can use the command:
# mminfo -a -q"group=groupname" where groupname is you savegroup and you
will get the volumes used by your group
Regards,
Bruno,
Brett Monroe <mr.bmonroe AT GMAIL DOT COM>
Sent by: Legato NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU>
02/08/2006 17:33
Please respond to
Legato NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU>; Please
respond to
Brett Monroe <mr.bmonroe AT GMAIL DOT COM>
To
NETWORKER AT LISTSERV.TEMPLE DOT EDU
cc
Subject
Re: [Networker] Finding a tape
Thanks for all the quick replies but I don't think I was being clear (in
fact I know I wasn't).
I have a script that is fired off by a savegroup compleation notification
and within it, I would like to deturmine the volumes used by said
savegroup
(and only said savegroup).
Thanks again.
--Brett
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type
"signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|