Removing hardware shouldn't change anything; but your mileage may vary.
A reconfig boot may rearrange the drives or change arm/robot coordinate.
Just run an inquire afterwards and adjust the jukebox that is left
accordingly.
Robert Maiello
Pioneer Data Systems
On Fri, 19 May 2006 09:55:08 -0700, Michael Coxe <mcoxe AT OPSWARE DOT COM>
wrote:
>Per a question I asked a few weeks ago (been OOO), will performing
>"touch /reconfigure" & rebooting a Solaris Legato server break any
>otherwise working Legato drive/jukebox configurations? I just want
>to clean up from the one removed jukebox, not the other.
>
>Sanity check before I perform this action.
>
>Regards,
>
> - michael
>
>Lee Hanel wrote:
>> did you force a reconfigure and reboot after removing the jukebox? If
>> not, I believe that solaris still shows the devices. to do this, just
>> "touch /reconfigure" and then reboot your server as you normally would.
>
>[snip]
>
>> On Fri, 2006-05-05 at 12:42 -0700, Michael Coxe wrote:
>>
>>>Hello folks,
>>>
>>>/etc/LGTOuscsi/inquire returns information about a SCSI
>>>jukebox that has been removed from our server.
>>>
>>>system: Solaris 5.7, Networker 6.1.4
>>>
>>>This stuff no longer attached:
>>>----------
>>>[email protected]:SONY SDX-500C 01 |Tape
>>>[email protected]:SONY SDX-500C 01 |Tape, /dev/rmt/5cbn
>>>[email protected]:SPECTRA 215 1010|Autochanger (Jukebox)
>>>
>>>Any suggestions on how to make this go away?
>>>I want to attached another device on this SCSI bus.
>>>I tried an "/etc/LGTOuscsi/lreset 2" but no luck.
>
>To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
>body of the email. Please write to networker-request AT listserv.temple DOT
>edu
if you have any problems
>wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
>via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
>=========================================================================
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
