Re: [Networker] How to get a tape library to use both tapes drives on inventory
2005-08-21 18:53:36
This email is to be read subject to the disclaimer below.
You need to go to jukebox properties and increase the jukebox parallelism
from its default of (number of tape drives - 1) to 2. This will make it
use all the available drives.
By default legato sets the jukebox parallelism to drives -1 so that there
is always one tape drive free to do restores or other operations at the
the same time.
Cheers,
Matt
Matthew S. Robert
National Data Backup & Retention Administrator
Information Systems & Communications
Ernst & Young
Direct: +612 9248 4784
Fax: +612 9248 5815
Matthew.Robert AT au.ey DOT com
Andrew Bridgeman <andrew.bridgeman AT CORUSGROUP DOT COM>
Sent by: Legato NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU>
20/08/2005 12:27 AM
Please respond to
Legato NetWorker discussion <NETWORKER AT LISTSERV.TEMPLE DOT EDU>; Please
respond to
Andrew Bridgeman <andrew.bridgeman AT CORUSGROUP DOT COM>
All email is logged and may be reviewed - Refer policy FP206
To
NETWORKER AT LISTSERV.TEMPLE DOT EDU
cc
Subject
[Networker] How to get a tape library to use both tapes drives on
inventory
I am running networker 7.1.3 on Windows and i am trying to get the 26 slot
Tape library we have to use both tape drives when i do an inventory on all
26 slots. For some reason it is just using Tape0. Where is the setting in
networker to set it to use both.
Any help is much appreciated.
Andrew Bridgeman
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type
"signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
--------------------
NOTICE - This communication contains information which is confidential and the
copyright of Ernst & Young or a third party.
If you are not the intended recipient of this communication please delete and
destroy all copies and telephone Ernst & Young on 1800 655 717 immediately. If
you are the intended recipient of this communication you should not copy,
disclose or distribute this communication without the authority of Ernst &
Young.
Any views expressed in this Communication are those of the individual sender,
except where the sender specifically states them to be the views of Ernst &
Young.
Except as required at law, Ernst & Young does not represent, warrant and/or
guarantee that the integrity of this communication has been maintained nor that
the communication is free of errors, virus, interception or interference.
Liability limited by a scheme approved under Professional Standards Legislation.
--------------------
If this communication is a "commercial electronic message" (as defined in the
Spam Act 2003) and you do not wish to receive communications such as this,
please forward this communication to unsubscribe AT au.ey DOT com
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the
body of the email. Please write to networker-request AT listserv.temple DOT edu
if you have any problems
wit this list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|