Re: [Networker] Correct st.conf for Sony SAIT-1 drive?

2004-12-04 10:06:22
Subject: Re: [Networker] Correct st.conf for Sony SAIT-1 drive?
From: Stan Horwitz <stan AT TEMPLE DOT EDU>
Date: Sat, 4 Dec 2004 10:05:31 -0500
On Sat, 4 Dec 2004, Oscar Olsson wrote:

>I've recently read the following document, which describes how drives
>should be configured in Solaris:
>Thus, I have the following in my st.conf:
>"SONY    SDZ-100", "Sony Super-AIT1", "SONY_SAIT";
>SONY_SAIT       =       1, 0x36, 0, 0x1d639, 4, 0x00, 0x00, 0x00, 0x00,0;

I have these entries

"SONY    SDZ-130",      "SONY 1/2 INCH S-AIT",          "SONY_SAIT";


SONY_SAIT       = 1, 0x36, 0, 0x19639, 4, 0x00, 0x00, 0x00, 0x00, 0;

which I copied and pasted directly from my server's st.conf file.
Our S-AIT drives are connected via a fiber hub so there might be
a difference if your drives are connected via traditional SCSI. If
you continue to have a problem, just get on the phone with your
Sony techncal contact and ask him or her to email you the proper
st.conf file entries. My equipment was installed by Sony who came
on-site so I know that what I have has Sony's blessing.

Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu