Networker

Re: [Networker] Staging save sets

2004-10-27 04:47:57
Subject: Re: [Networker] Staging save sets
From: "Wood, R A (Bob)" <WoodR AT CHEVRONTEXACO DOT COM>
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Date: Wed, 27 Oct 2004 09:46:48 +0100
Peter,
        No problem staging, just remember that the high and low water
marks are for the whole disk (i.e. if you have more than one device
defined on a disk then networker will use the size of the disk as the
gauge for high/low water). Minor point but can catch you out. :)


-----Original Message-----
From: Legato NetWorker discussion [mailto:NETWORKER AT LISTMAIL.TEMPLE DOT EDU]
On Behalf Of Pieter Boshoff
Sent: 27 October 2004 08:13
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: [Networker] Staging save sets


Hello all,

I would like to know if anyone out there is using the stage function? I
want to start using it to stage my backups from d2t.

My config:
Win2k using Networker 7.1.2 Build 325, using EMC CX600 for disk backups
and Dell 132T for tapes.

I will appreciate any comments.

Pieter Boshoff


--
Note: To sign off this list, send a "signoff networker" command via
email to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can also
view and post messages to the list. Questions regarding this list should
be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

<Prev in Thread] Current Thread [Next in Thread>