>
> Hi,
>
> I notice I receive identical output for all of the following commands
> wherein I list savesets since 4 PM (EDT) yesterday:
>
> mminfo -s server -q 'savetime>=10/18/04 4 pm'
> mminfo -s server -q 'savetime>=10/18/04 16:00'
> mminfo -s server -q 'savetime>=1098129600'
This uses -q, which implies -a.
> HOWEVER, if I instead run:
>
> mminfo -s server -t 'yesterday 4 pm' or 'yesterday 16:00'
This doesn't use q, c, m, N, or o and you haven't explicitly used -a.
My assumption is that this is the difference. Because I've been bitten
by similar issues so many times, I just always use -a.
See if that makes everything work the same.
--
Darren Dunham ddunham AT taos DOT com
Senior Technical Consultant TAOS http://www.taos.com/
Got some Dr Pepper? San Francisco, CA bay area
< This line left intentionally blank to confuse you. >
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list. Questions regarding this list
should be sent to stan AT temple DOT edu
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|