Craig,
Staging is done on a device basis, so as you guessed, you would need to
seperate it out if you are strictly using the policies in the GUI. Or you
could run nsrstage from command line coupled with an mminfo command to feed
in only the full SSID's.  There is an example in the man page you can build
upon.


Patrick

On Tue, 31 Aug 2004 13:24:27 -0400, Craig Guest <craig AT ISI DOT EDU> wrote:

>Greetings,
>
>I am using Networder 7.1 on Solaris system testing DiskBackup option.
>Currently all my save sets (all levels) are going to one adv_file
>filesystem approximately 2 TB's.  My goal is to stage only level Full's
>from disk to DLT tape.
>
>I setup a staging policy to a Pool with the following configuration:
>
>   Pool:      Offsite
>   Groups:    null
>   Save Sets: null
>   Levels:    full
>   Device:    /dev/rmt/0cbn
>
>
>The problem is "all level" backups are being staged to tape.
>
>Can I filter level full's from this adv_file device, or do I need to
>create a separate adv_file system containing only level full's?
>
>
>Thanks,
>Craig
>
>Craig Guest
>USC/Information Sciences Institute
>craig AT isi DOT edu    http://www.isi.edu/
>
>--
>Note: To sign off this list, send a "signoff networker" command via email
>to listserv AT listmail.temple DOT edu or visit the list's Web site at
>http://listmail.temple.edu/archives/networker.html where you can
>also view and post messages to the list.
>=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=