Re: [Networker] Legato Networker Migration
2004-04-07 12:04:00
On Wed, 7 Apr 2004, Ciolek, Ken wrote:
>I am in the process of doing a migration from Backup Exec to Legato
>Networker. Currently there is a autochanger attached but is being used at a
>stand alone tape drive. After I nstalled Legato and disbaled Backup Exec I
>tried to do a JBCONFIG to setup the autochanger and could not see it. I
>remember in the past a reboot is required for Legato to gain control and
>wanted to know if there was any other way of doing it w/o the reboot since
>uptime is critical.
In questions such as your's it is nearly impossible to offer any specific
recommendations without knowing which version of NetWorker you are using
on your server, and details about your hardware and OS configuration.
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|