[Networker] Legato Networker Migration
2004-04-07 11:50:07
I am in the process of doing a migration from Backup Exec to Legato
Networker. Currently there is a autochanger attached but is being used at a
stand alone tape drive. After I nstalled Legato and disbaled Backup Exec I
tried to do a JBCONFIG to setup the autochanger and could not see it. I
remember in the past a reboot is required for Legato to gain control and
wanted to know if there was any other way of doing it w/o the reboot since
uptime is critical.
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] Legato Networker Migration,
Ciolek, Ken <=
|
|
|