Code 0x00 for density means use "default" drive density.
You have to find if this means compress or not in the drive specs and/or
switches/jumpers setup.
Once you find from the drive documentation what is the "density" code
for compression you can specify this with the density=0xYZ in your
stinit.def under the modeX line.
Itzik

> -----Original Message-----
> From: Legato NetWorker discussion
[mailto:NETWORKER AT LISTMAIL.TEMPLE DOT EDU] On Behalf Of Yura Pismerov
> Sent: Tuesday, February 24, 2004 16:32
> To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
> Subject: [Networker] AIT-3 under Linux
> 
>     Hi everybody,
> 
>     I need stinit.def entry for AIT-3 with h/w compression turned on.
>     All the examples I found refer to density=0x00 which I assume does
> not imply h/w compression, right ?
>     What density code should I use ? Or should I use "compression=1"
> instead ?
> 
>     TIA.
> 
> --
> Note: To sign off this list, send a "signoff networker" command via
email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

**************************************************************************************************
The contents of this email and any attachments are confidential.
It is intended for the named recipient(s) only.
If you have received this email in error please notify the system manager or  
the 
sender immediately and do not disclose the contents to any one or make copies.

MBI - System Team
**************************************************************************************************

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=