Hi Kent,

one of the things I've only recently seen is that with Networker v6.1.3
the *client parallelism* value takes precedence over the savegroup
parallelism value. (I always thought that the group values would
over-ride the client values.. go figure)

Try increasing your client parallelism values. If that doesn't help,
when you're calling the savegrp command make sure you specify the "-N #"
option, where # is the number of sessions you want to run in the group.

HTH,
John

> -----Original Message-----
> From: Kent Holloway [mailto:Kent.Holloway AT ONVOY DOT COM] 
> Sent: Wednesday, 31 December 2003 04:30
> To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
> Subject: [Networker] Target sessions on drives not working properly.
> 
> 
> I have 4 SDLT 220 drives on a StorageTek L180, I am trying to 
> load up 1
> drive with 10-15 savesets.
> 
> I have a group with 4 clients in it each with 4-5 savesets. 
> Clients are each set at Parallelism of 4.
> Server Parallelism is 48.
> Each Tape drive is set at Parallelism of 20.
> 
> When I run the savegroup I only get 4 sessions per drive.
> 
> I have stopped and restarted all Networker processes just in case and
> that has not made any difference.
> 
> Backup Server: Solaris (Sparc) 8 / Networker 6.1.4 Network Edition
> Clients: Solaris (Sparc) 8 clients running Networker 6.1.3
> 
> Any idea as to what I'm missing here?
> 
> Thanks.
> 
> --
> Note: To sign off this list, send a "signoff networker" 
> command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
> 

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=