Hello,
before I patch our production system from 6.1.3 to 6.1.4, I wanted to try
6.1.4 on a test system (fresh installation, Linux, Overland LibraryPro + one
AIT-2 drive).
And here, with a fresh installed system, right after having labeled the 1st
tape, I get only this error:
box_unload: unload failure detected - retrying
box_unload: retry: start time = 1072113735
box_unload: retry: sleeping 30
box_unload: retry: failed - will retry
I see this error occasionally on our production system also (StorageTek
L700e + 5 LTO-1 drives).
What is wrong here? Why is this out-of-the-box setup not working?
Regards
Olaf
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|