Re: [Networker] Adding Storage Node
2003-10-21 12:44:23
Hi,
You would have to configure the client in Legato.
Make sure the SCSI is setup 100% on the client (acces to tapes etc).
And then in the client configuration properties you add in the "storage
node" box its own name.
You would then have to add the device (or library) to Legato in the devices
tab. (rd=).
All pretty wel documented though.
Regards,
riaan
-----Original Message-----
From: Ray lee [mailto:rlee0004 AT TAMPABAY.RR DOT COM]
Sent: Tuesday, October 21, 2003 6:15 PM
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: [Networker] Adding Storage Node
We are adding a new StorageNode/Client to our current setup. What are the
correct steps in adding a new SN/Client into Legato?
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|