Hello respected networkers,
I am running legato 6.1.3 on HPUX 10.20 and my libraray is L180 with SDLT-320
drives. I am creating the devices by following command:
mksf -d stape -I 10 -b 147 -c 16 -u -n
When I checked with the documentation , I found taht SDLT-320 density is 193
Kbpi , so I was wondering should I use -b 193 or -b 147. Further the -c option
is for the compression is the 16 value is correct for 2:1 ratio.
Thanks much,
Mukesh
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|