Hi Yura,

Yes, that is correct.  As suggested on this list, Iv'e tried 'nsrjb -j <Name>
-I' and still loaded each tape (previously labeled) into the drives.

Regards,
        /\/elson


On Wed, 28 May 2003, Yura Pismerov wrote:

> "David E. Nelson" wrote:
> >
> > Hi All,
> >
> > We've got an L180, 6.1.3, and Solaris 8.  All tapes are barcoded and the 
> > tape
> > label == barcode.  When we add tapes via the CAP, we have to do 'nsrjb -j
> > L180-1 -IEv' to re-inventory the slot that were just filled.  Is there any 
> > way
> > around this so that NW can just use the barcodes and not have to physically
> > load/unload each tape that was added via the CAP?
>
> I was under impression that Networker loads the tape that is being
> inventoried only in case if the barcode is not in the media database
> yet. Are you saying all the tapes that you add were labeled before ?
>
>
> >
> > Thanks,
> >         /\/elson
> >
> > --
> > ~~ ** ~~  If you didn't learn anything when you broke it the 1st ~~ ** ~~
> >                         time, then break it again.
> >
> > --
> > Note: To sign off this list, send a "signoff networker" command via email
> > to listserv AT listmail.temple DOT edu or visit the list's Web site at
> > http://listmail.temple.edu/archives/networker.html where you can
> > also view and post messages to the list.
> > =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>
> --
> Note: To sign off this list, send a "signoff networker" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>

--
~~ ** ~~  If you didn't learn anything when you broke it the 1st ~~ ** ~~
                        time, then break it again.

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=