I think by using the -E parameter you basically force Networker to verify
each tape by reading its tape label. Try it with just -Iv.
David Werth
UPS Aviation Technologies
(formerly: II Morrow)
Salem, Oregon
iim1dfw AT at.ups DOT com
-----Original Message-----
From: David E. Nelson [mailto:david.nelson AT ni DOT com]
Sent: Wednesday, May 28, 2003 1:47 PM
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: [Networker] Bypassing library inventory when added volumes via the
CAP
Hi All,
We've got an L180, 6.1.3, and Solaris 8. All tapes are barcoded and the
tape
label == barcode. When we add tapes via the CAP, we have to do 'nsrjb -j
L180-1 -IEv' to re-inventory the slot that were just filled. Is there any
way
around this so that NW can just use the barcodes and not have to physically
load/unload each tape that was added via the CAP?
Thanks,
/\/elson
--
~~ ** ~~ If you didn't learn anything when you broke it the 1st ~~ ** ~~
time, then break it again.
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|