What bus are the drives showing up on when you lsdev?  The ones
you are seeing could be left over from the SCSI-based config.
Inquire -l sends queries down the bus directly if I remember
correctly, so if the devices are attached, it should find them.

Try this:
-rmdev the drives and the autochanger from AIX if they aren't on
the bus from the fibre card
-reset the the fibre bridge on the 3583 (you can do this
serial, over the network if it's configured, or shutdown / restart it)
-do an inquire -l, and see if the drives and changer are there
-if so, run cfgmgr to get AIX up to speed with them
-rmdev the smc0 device (and any other smc's) so that Networker can access
it (I don't know if they fixed this problem yet or not)

If you don't see everything after the bridge reset, check the 3583
to make sure everything is cabled correctly, fibre bridge is configured
to show all the drives,...etc.

-ed shipe

> -----Original Message-----
> From: Gary J Jasionowicz [mailto:gary_j_jasionowicz AT FLEETCL DOT COM]
> Sent: Monday, March 17, 2003 4:42 PM
> To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
> Subject: [Networker] configuring a fibre attached library
>
>
> I am currently running Networker 6.1.1 on AIX 4.3.3 using an IBM 3583
> library.  The library was SCSI attached to the networker server and
> working. I am trying to attach the library via fibre directly into the
> networker server, one day I would like to put the library on
> the SAN but I
> am taking it one step at a time.  When I attach the library
> via fibre AIX
> sees all 4 tape drives and the changer device, when I do an
> lsdev -Cc tape.
> However when I do a inquire command no tape devices are
> shown.  When I do
> an inquire -l command it does show two tape devices one is
> rmt1.1 and the
> other just says Tape.  When I try to configure the jukebox
> using jbconfig
> and option 2 the only thing it comes up with is my cdrom
> device, no tape
> devices.  Any help would be greatly appreciated.  Thanks.
>
> --
> Note: To sign off this list, send a "signoff networker"
> command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=