This is the most important one.  If you overlook this, you will have pain
and spend days researching it.  So, I'll say it again:  make sure that all
of your systems on the SAN that share the tape drives are configured to use
the same block size.  Yes, NetWorker does 'request' the same block size
during writes on all of its supported platforms; but, the SCSI/FC HBA must
also support this same block size.

tl

Terry Lemons
CLARiiON Applications Integration Engineering
        EMC²            
where information lives

4400 Computer Drive, MS D239
Westboro MA 01580
Phone: 508 898 7312
Email: Lemons_Terry AT emc DOT com


-----Original Message-----
From: Dag Nygren [mailto:dag AT NEWTECH DOT FI]
Sent: Saturday, March 08, 2003 5:53 PM
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: Re: [Networker] DDS between NT & Unix


> John,
> 
> I know different customers where it works perfectly.
> No specific problem : just have to fill correctly
> the device names when creating the DDS devices but
> for the rest, it's ok.

Just remember the blocksizes (as said in documentation)

BRGDS

Dag

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=