The release notes tell about the "service mode."  On my server, it appears
that if a device experiences an I/O error, the device will go into service
mode, allowing the nsrmmd to finish what it is doing and then eject the
volume.  However, the device remains in service mode and will not allow any
other mounts.  you can however run commands with the -f switch like nsrjb -I
-f /devicepath.

Christopher Adkisson


-----Original Message-----
From: Baris Yeter [mailto:barye AT KOCBANK.COM DOT TR]
Sent: Tuesday, December 17, 2002 7:58 AM
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: [Networker] Legato 6.1.3

Hello,

1. What is the function of the "service mode" in Device Attributes in Legato
6.1.3?
2. Is there any documentation Legato Admistration Guide for 6.1.3?

P.S: Thanks. I downloaded 6.1.3. And I set up.

Best Regards

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=