I have no problem withdrawing many volumes at the same time. Just select
multiple slots in your withdraw command (or select the appropriate slots on
the GUI).

Regards
Bob

-----Original Message-----
From: Adkisson, Christopher [mailto:CAdkisson AT BBANDT DOT COM]
Sent: 04 November 2002 15:27
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: Re: [Networker] STK Silo CAP

I use a script that builds a list of volumes to export and then just passes
them through a loop, doing an nsrjb -w on each volume.  Is this what you're
asking?

Christopher Adkisson


 -----Original Message-----
From:   Joel Fisher [mailto:jfisher AT WFUBMC DOT EDU]
Sent:   Monday, November 04, 2002 10:03 AM
To:     NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject:        [Networker] STK Silo CAP

Hey All,

I'm in the process of setting up a StorageTek 9310 Silo to be used with
Networker 6.0.3.  I've notice that the documentation says that Legato
can only export 1 volume at a time?!?!  Is anyone using a 9310 and run
into this problem?  I suppose you can pass a list of volsers to acsls
directly and export the volumes outside of Networker control... but that
could be dangerous.

Any thoughts/ideas appreciated.

Solaris 2.6/Solstice Backup 6.0.3/Sun E450/STK 9310

Thanks,

Joel

--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=