Check to seen if you configure storage maps or selective presentation within
the SNC  ( a FC/SCSI bridge I believe ). I have seen similar issues
with other bridges.

Ian Mcleavey
Black & Decker

-----Original Message-----
From: Legato_Networker [mailto:Legato_Networker AT 163 DOT COM]
Sent: 21 October 2002 12:24
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: [Networker] Help!!!!


Hello , all

Environment :

Host: Sun 280R  + solaris 8
HBA card:  Qlogic 2200
FC switch : brocade 2800
Tape Library : ADIC scalar 1000 + 2 LTO driver + SNC 5000
Disk Arrary : HDS



Problem :

I can see the HDS' disks ,but I can not see the tape library's drivers and
robot.
from the /var/adm/messages , I can not see the IBM LTO driver

Does any one can give me a hand ?

Thanks a lot








--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=