can you check from the switch whether the tape library fc is up.
also check the topology, it may good if you are running all fabric.
even though the brocade will take care the topology.

cheers - han


At 10/21/2002 09:08 PM, Legato_Networker wrote:

Hi,  Bob ,Thank you for your message.

I have no configure any zoning on the FC switch .

I am afraid that if my st.conf  file under the /kernel/drv/ directory is
not correct .

did any one can mail me a correct example to me  with the similar
environment . Thanks in advance .

Thanks again

Eric


----- Original Message -----
From: Wood, R A (Bob) <WoodR AT ChevronTexaco DOT com>
To: 'Legato NetWorker discussion' <NETWORKER AT LISTMAIL.TEMPLE DOT EDU>;
'Legato_Networker' <Legato_Networker AT 163 DOT COM>
Sent: Monday, October 21, 2002 8:23 PM
Subject: RE: [Networker] Help!!!!


> Is zoning active in the switch?
>
> -----Original Message-----
> From: Legato_Networker [mailto:Legato_Networker AT 163 DOT COM]
> Sent: 21 October 2002 12:24
> To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
> Subject: [Networker] Help!!!!
>
> Hello , all
>
> Environment :
>
> Host: Sun 280R  + solaris 8
> HBA card:  Qlogic 2200
> FC switch : brocade 2800
> Tape Library : ADIC scalar 1000 + 2 LTO driver + SNC 5000
> Disk Arrary : HDS
>
>
>
> Problem :
>
> I can see the HDS' disks ,but I can not see the tape library's drivers and
> robot.
> from the /var/adm/messages , I can not see the IBM LTO driver
>
> Does any one can give me a hand ?
>
> Thanks a lot
>
>
>
>
>
>
>
>

cheers - han

--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=