I was just about finished with the cloning for the weekend and I was removing 
the clones from the jukebox.  I then went through them to label them when I 
noticed one volume had no savesets when I went to browse it.  It is one of 5 
tapes that is housing a large volume an some small savesets.  

My question is, had anyone figured out a way to get the tape readable so I can 
clone access the savesets on that tape?  I checked mminfo for the that tape and 
I can see the save sets but when I browse through the GUI, it says there are no 
savesets on this volume.

Setup is NT4.0sp6a Server networker v. 6.1.1, DLT IV tape, 2000 clients with v. 
6.1.1

Any help or direction would be appreciated.


Thanks,
Phil M.

--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=