[Networker] problem browsing index after scanner command
2002-09-13 06:12:53
Hi,
I'd appreciate any ideas on this.
Scenario:
I've just installed Networker V6.03 on Windows NT4 in order to get data off a
tape that was created using Networker V6.02.
I created the relevant client and pool. I ran 'scanner -i -vv' on the tape and
it built the index. I can browse the index and everything looks fine except
when I click 'required volumes', it returns 'unknown'. If I mark the file and
click 'start', it comes back with 'cannot find volume'. There is only one
volume involved, the one I scanned. I have done this many times using Networker
V5.* without problem. Has anyone come across this?
Regards and Thanks,
Tom.
--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- [Networker] problem browsing index after scanner command,
Moore, Tom (Galway) <=
|
|
|