Re: [Bacula-users] restore director

Hello,

2015-06-29 8:08 GMT+02:00 scar <scar AT drigon DOT com>:

this is extremely frustrating! :(
im reading the section about bscan[1],

No, you need a bextract command to restore all your configuration and your catalog database backup from archive volumes (do you have your bsr files somewhere, right?).

When you have a catalog database backup you can load it into your new and fresh database instance. Then with restored config files you can succesfully run your backup system. It should take about 15min to recover (excluding OS installation and configuration, as you already have one) depending on catalog database size.

If you lot all your bsr files, you need to check where your config files and catalog database backups are located, which will take a lot of time. If you do not perform a catalog database backup then you will need to use bscan to populate all your backup metadata to catalog, which will take more time again.

best regards

Radosław Korzeniewski
radoslaw AT korzeniewski DOT net

------------------------------------------------------------------------------
Monitor 25 network devices or servers for free with OpManager!
OpManager is web-based network management software that monitors 
network devices and physical & virtual servers, alerts via email & sms 
for fault. Monitor 25 devices for free with no restriction. Download now
http://ad.doubleclick.net/ddm/clk/292181274;119417398;o

_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users