The problem was that I specified LT04 (zero) in one section and LTO4 in the 
other. Doh! Thanks.

-----Original Message-----
From: John Drescher [mailto:drescherjm AT gmail DOT com] 
Sent: Tuesday, August 17, 2010 12:32 PM
To: Jeremiah D. Jester; bacula-users
Subject: Re: [Bacula-users] status is append, not in pool?

> I just entered 15 new blank tapes and am attempting to run a job on my new
> bacula install for my Dell 124T. When I try to run a job I get the following
> messages. Any ideas?
>
> 17-Aug 12:01 bacula02-dir JobId 40: Fatal error:
>
>      Storage daemon didn't accept Device "DELL_124T" because:
>
>      3924 Device "DELL_124T" not in SD Device resources.
>
I believe this means bacula thinks there is a mismatch in naming your
tape drive between bacula-dir.conf and bacula-sd.conf

John

------------------------------------------------------------------------------
Sell apps to millions through the Intel(R) Atom(Tm) Developer Program
Be part of this innovative community and reach millions of netbook users 
worldwide. Take advantage of special opportunities to increase revenue and 
speed time-to-market. Join now, and jumpstart your future.
http://p.sf.net/sfu/intel-atom-d2d
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users