I’m getting a bunch of error messages stating a “Volume
data error” when I run ‘label barcodes’. John Drescher
advised me to rewind that tape and write and eof to clear the data. However, in
this case I did notice that the last line of output states that it was the volume
was created successfully. Interesting enough the volume does not appear when I issue
a ‘status slots’. Any thoughts on this?
Here is the full error message output for one of the
volumes.
Thanks,
JJ
Sending label command for Volume "KL0433" Slot 14
...
3307 Issuing autochanger "unload slot 13, drive 1"
command.
3304 Issuing autochanger "load slot 14, drive 1"
command.
3305 Autochanger "load slot 14, drive 1", status
is OK.
block.c:275 Volume data error at 0:0! Wanted ID:
"BB02", got "". Buffer discarded.
3000 OK label. VolBytes=64512 DVD=0
Volume="KL0433" Device="Drive2" (/dev/nst1)
Catalog record for Volume "KL0433", Slot 14
successfully created.
Jeremiah Jester
Senior Informatics Specialist
UW Microbiology - Katze Lab
Box 357242
P: 206-732-6185