Bacula-users

Re: [Bacula-users] IBM TS3100 autochanger

2010-06-01 08:42:15
Subject: Re: [Bacula-users] IBM TS3100 autochanger
From: Win Htin <win.htin AT gmail DOT com>
To: bacula-users AT lists.sourceforge DOT net
Date: Tue, 1 Jun 2010 08:31:15 -0400
On Tue, Jun 1, 2010 at 8:29 AM, Win Htin <win.htin AT gmail DOT com> wrote:
>> Message: 12
>> Date: Sun, 30 May 2010 08:17:27 -0400
>> From: masker <bacula-forum AT backupcentral DOT com>
>> Subject: [Bacula-users]  IBM TS3100 autochanger
>> To: bacula-users AT lists.sourceforge DOT net
>> Message-ID: <1275221847.m2f.335972 AT www.backupcentral DOT com>
>>
>> Phil Stracchino wrote:
>>>
>>> What is this lin-tape you speak of?
>>>
>>> If your Linux kernel is properly configured (i.e, SCSI HBA support, SCSI
>>> tape support, and the PERC6 low-level SCSI driver enabled), it should
>>> Just Work.  If those aren't compiled into your kernel, see if you have
>>> them present as modules.
>>>
>>
>>
>> The "lin-tape" or "lin_tape" means the driver name of IBM ULTRIUM-HH5 tape 
>> drive.
>> I've download the lin_tape-1.38.0-1.src.rpm from IBM website. But I can't 
>> compile it in Debian 5.0.4.
>> The SAS HBA driver is "mpt2sas", it was installed in my system, 
>> successfully. Then I could use "mt -f /dev/st0 status", but I got error 
>> message like "read error.. " if I type " mt -f /dev/st0 tell".
>> Under this situation , it could write by "tar" command, but show "write 
>> error..." after several hours.
>> If I connect the tape drive to a machine of CentOS with right driver, it 
>> show "/dev/IBMtape0" as the device name, and I could have right answer by 
>> "mt -f /dev/IBMtape0 tell"
>>
>> So. I need some help. If anyone have any suggestion to help me install the 
>> tape in Debian OS?


Just one word from someone who have tested and am using both TS3100 &
TS3200s with LTO4 drives; STAY AWAY from lin-tape. It is very kernel
specific and even when you think everything is working fine, it will
come back and bite you later.

I do not use Debian but in RedHat 4 and 5, all I have to do is make
sure "mt-st" and "mtx" packages are installed.

Following is the comparison of with and without lin-tape devices under /dev.

Example WITH lin-tape:           # mt -f /dev/IBMtape0 status
Example WITHOUT lin-tape:    #  mt -f /dev/st0 status

HTH,
Win

------------------------------------------------------------------------------

_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users

<Prev in Thread] Current Thread [Next in Thread>