I note that it is possible to run clone jobs by using "Run = <jobname of
current job> in the Job resource.
What I would like to do is make 2 tapes (Volumes) that are exact copies,
but with only one catalog entry, used if either tape is restored.
1. Does cloning acheive this?
2. Can cloning be performed on a single drive?
The doc is a little unclear, stating:
"By using the cloning keywords (see below), you can backup the same data
(or almost the same data) to two or more drives at the same time."
Then further down stating:
"Please note that all cloned jobs, as specified in the Run directives
are submitted for running before the original job is run (while it is
being initialized). This means that any clone job will actually start
before the original job, and may even block the original job from
starting until the original job finishes unless you allow multiple
simultaneous jobs. Even if you set a lower priority on the clone job, if
no other jobs are running, it will start before the original job."
The implication here is that the clone would run first on one volume and
the tape could be changed to run the original job.
Regards,
Richard
------------------------------------------------------------------------------
Throughout its 18-year history, RSA Conference consistently attracts the
world's best and brightest in the field, creating opportunities for Conference
attendees to learn about information security's most important issues through
interactions with peers, luminaries and emerging and established companies.
http://p.sf.net/sfu/rsaconf-dev2dev
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|