Hemant,
On Tue 20 May 2008 14:12, Hemant Shah wrote:
> Folks,
>
> Where can I find the description of the each of the volume status?
> I looked at the online manual but could not find it.
Can't answer this.
> After my full backups are done, the tape has volstatus of Append. I would
> like to change it so that it cannot be used again. Should I change it to
> "Used" or "Full".
I would suggest Used.
Use bconsole: Update Volume, Volume Status (#1), (select volume), Used
(#5).
Or, bconsole: update volume=XXX volstatus=used
HTH!
cmr
> Hemant Shah
> E-mail: hjrrs AT yahoo DOT com
>
>
>
>
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2008.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> Bacula-users mailing list
> Bacula-users AT lists.sourceforge DOT net
> https://lists.sourceforge.net/lists/listinfo/bacula-users
--
Debian 'Etch' - Registered Linux User #241964
--------
"More laws, less justice." -- Marcus Tullius Ciceroca, 42 BC
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|