16 slots, 16 loads/reads?
2009-01-27 11:04:17
Hi All,
I am having an issue where my superloader 3 LTO3 changer goes through and reads
all FULL slots until it gets to 16. So, tapes are loaded and read until 16
slots are read, but it is reading the same slots over and over.
I have 16 slots, but only am using 7 of them right now. The result is that I am
getting WAY more wear on my changer than I should be getting (and time is wasted).
Is there a way to get barcodes working in this version of amanda so that it
wouldn't even have to do the reads, and if not, is there a way to tell it to
stop reading until it gets to 16 (ONLY READ FULL SLOTS)???
Note that it does this every run AND every amcheck. . .
Details:
amanda version 2.6.0p2
CentOs 5.2
Quantum Superloader 3 LTO3 16 slot
changer.conf:
changerdev=/dev/sg3
firstslot=1
lastslot=16
havebarcode=1
havereader=1
poll_drive_ready=10
Max_drive_wait=99
unloadpause=10
driveslot=0
offline_before_unload=1
OFFLINE_BEFORE_UNLOAD=1
Thanks!
-Nick
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- 16 slots, 16 loads/reads?,
Nick Brockner <=
|
|
|