|
S3 Backup using 2.6.1b2
2009-01-08 11:50:26
I'm not too sure what's going on - it takes about 10 days to run the backup. Here's the results from the run that started on 12/27 and the results from amstatus on the backup that started running yesterday. I checked S3, and it used up a little over 5000 "tapes". Is there a time / amount limit?
Hostname: ubuntu
Org : music
Config : music
Date : December 27, 2008
The dumps were flushed to tape musicSet1-0010.
*** A TAPE ERROR OCCURRED: [Could not find a tape to use].
No dumps are left in the holding disk. 0M
The next tape Amanda expects to use is: 1 new tape.
The next new tape already labelled is: musicSet1-0010.
STATISTICS:
Total Full Incr.
-------- -------- --------
Estimate Time (hrs:min) 0:00
Run Time (hrs:min) 251:14
Dump Time (hrs:min) 0:00 0:00 0:00
Output Size (meg) 0.0 0.0 0.0
Original Size (meg) 0.0 0.0 0.0
Avg Compressed Size (%) -- -- --
Filesystems Dumped 0 0 0
Avg Dump Rate (k/s) -- -- --
Tape Time (hrs:min) 250:39 250:39 0:00
Tape Size (meg) 56035.2 56035.2 0.0
Tape Used (%) 56.0 56.0 0.0
Filesystems Taped 1 1 0
Chunks Taped 1 1 0
Avg Tp Write Rate (k/s) 63.6 63.6 --
STATISTICS:
Total Full Incr.
-------- -------- --------
Estimate Time (hrs:min) 0:00
Run Time (hrs:min) 251:14
Dump Time (hrs:min) 0:00 0:00 0:00
Output Size (meg) 0.0 0.0 0.0
Original Size (meg) 0.0 0.0 0.0
Avg Compressed Size (%) -- -- --
Filesystems Dumped 0 0 0
Avg Dump Rate (k/s) -- -- --
Tape Time (hrs:min) 250:39 250:39 0:00
Tape Size (meg) 56035.2 56035.2 0.0
Tape Used (%) 56.0 56.0 0.0
Filesystems Taped 1 1 0
Chunks Taped 1 1 0
Avg Tp Write Rate (k/s) 63.6 63.6 --
taper: Tape with label musicSet1-0002 is still active and cannot be overwritten.
taper: slot 3:read label `musicSet1-0003', date `20081201190003'.
taper: Tape with label musicSet1-0003 is still active and cannot be overwritten.
taper: slot 4:read label `musicSet1-0004', date `20081202190002'.
taper: Tape with label musicSet1-0004 is still active and cannot be overwritten.
taper: slot 5:read label `musicSet1-0005', date `20081204190003'.
taper: Tape with label musicSet1-0005 is still active and cannot be overwritten.
taper: slot 6:read label `musicSet1-0006', date `20081205190002'.
taper: Tape with label musicSet1-0006 is still active and cannot be overwritten.
taper: slot 7:read label `musicSet1-0007', date `20081206190002'.
taper: Tape with label musicSet1-0007 is still active and cannot be overwritten.
taper: slot 13:read label `musicSet1-0013', date `20081209190003'.
taper: Tape with label musicSet1-0013 is still active and cannot be overwritten.
taper: slot 14:read label `musicSet1-0014', date `20081210190002'.
taper: label "musicSet1-0014" matches labelstr but it is not listed in the tapelist file.
taper: slot 1:read label `musicSet1-0001', date `20081211190002'.
taper: Tape with label musicSet1-0001 is still active and cannot be overwritten.
taper: tape musicSet1-0010 kb 57380001 fm 1 [OK]
DUMP SUMMARY:
DUMPER STATS TAPER STATS
HOSTNAME DISK L ORIG-MB OUT-MB COMP% MMM:SS KB/s MMM:SS KB/s
-------------------------- ------------------------------------- -------------
localhost -rive/Music 0 56035 -- FLUSH 15038: 63.6
(brought to you by Amanda version 2.6.1b2)
I ran amlabel -f on all the tapes after this ran, but if I run
amoverview music
Warning: no log files found for tape musicSet1-0014 written 2009-01-07 19:00:03
date 01
host disk 07
Here's my disklist
localhost /samba/bigdrive/Music comp-user-tar
and amanda.conf
org "music" # your organization name for reports
mailto "mlb" # space separated list of operators at your site
dumpcycle 1 week # the number of days in the normal dump cycle
runspercycle 7 # the number of amdump runs in dumpcycle days
# (1 week * 5 amdump runs per week -- just weekdays)
tapecycle 14 tapes # the number of tapes in rotation
# 1 week (dumpcycle) times 5 tapes per week (just
# the weekdays) plus a few to handle errors that
# need amflush and so we do not overwrite the full
# backups performed at the beginning of the previous
# cycle
runtapes 1 # number of tapes to be used in a single run of amdump
tpchanger "chg-multi" # the tape-changer glue script
tapedev "S3:" # the no-rewind tape device to be used
device_property "S3_ACCESS_KEY" "My Access Key"
device_property "S3_SECRET_KEY" "My Secret Key"
device_property "S3_SSL" "false"
changerfile "changer.conf"
tapetype HARDDISK # what kind of tape it is (see tapetypes below)
holdingdisk hd1 {
directory "/samba/smalldrive/dumps/music"
use -1000Mb
}
holdingdisk hd2 {
directory "/samba/bigdrive/dumps/music"
use -1000 Mb
}
label_new_tapes "musicSet1-%%%%" # Enable auto labeling
labelstr "^musicSet1-[0-9][0-9]*$" # label constraint regex: all tapes mus$
dtimeout 1800 # number of idle seconds before a dump is aborted.
ctimeout 30 # maximum number of seconds that amcheck waits
# for each client host
etimeout 300 # number of seconds per filesystem for estimates.
define dumptype global {
comment "Global definitions"
auth "bsdtcp"
}
define dumptype gui-base {
global
program "GNUTAR"
comment "gui base dumptype dumped with tar"
compress none
index yes
}
define tapetype HARDDISK {
comment "Virtual Tapes"
length 100000 mbytes
}
includefile "advanced.conf"
includefile "/var/lib/amanda/template.d/dumptypes"
includefile "tapetypes"
|
| <Prev in Thread] |
Current Thread |
[Next in Thread>
|
- S3 Backup using 2.6.1b2,
Matt Burkhardt <=
|
|
|
