On Wed, May 7, 2008 at 2:21 PM, Nathan Barss <nbarss AT cambric DOT com> wrote:
> Please forgive my n00bness. This is probably a simple configuration error on
> my part, but I am having a problem getting Amanda to flush to tape.
> Everything else seems to work fine. The report when I run amflush looks like
> this (and is similar to the report from amdump):
Is it possible that the dumps are too large to fit on that tape? From
the snippets of the amflush log, it looks like the taper starts
writing to the tape, but then fails to complete any of the dumps. Do
you have tape spanning enabled?
Dustin
--
Storage Software Engineer
http://www.zmanda.com
|