Re: how to automate tape changing
2004-10-21 08:22:21
Jukka Salmi <j+amanda AT 2004.salmi DOT ch> writes:
> > >Is it possible to automate the process of loading the needed tapes?
(tape changing with amrecover)
> > Yes. I'm using the following tape device setup to do this:
> > amrecover_changer "/dev/nrtape"
> > amrecover_do_fsf yes
> > amrecover_check_label yes
> >
> > It's amrecover_changer that does the trick; essentially it tells
> > amrecover to use the tape changer or the tape device is set to /dev/nrtape.
I'm using this now too; works fine.
After each automatically loaded tape amrecover still prompts to
continue. Is this expected behaviour?
Sven
|
|
|