Toralf Lund wrote:
Other possible error sources that I think I have eliminated:
1. tar version issues - since gzip complains even if I just uncopress
and send the data to /dev/null, or use the -t option.
2. Network transfer issues. I get errors even with server
compression, and I'm assuming gzip would produce consistent output
even if input data were garbled due to network problems.
3. Problems with a specific amanda version. I've tried 2.4.4p1 and
2.4.4p3. Results are the same.
4. Problems with a special disk. I've tested more than one, as target
for "file" dumps as well as holding disk.
5. Hardware errors, e.g. in bad RAM (on a computer without ECC), or
disk controller, or cables.
If one single bit is flipped, then gzip produces complete garbage from
that point on. Maybe you're only seeing it in such large backups with
gzip, but it happens (less often) in other cases too.
Any tools available to test the hardware?
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|
