Re: amrecover question
2004-04-01 14:52:10
Hi, Robert,
on Donnerstag, 01. April 2004 at 21:21 you wrote to amanda-users:
DRC> What can I do to correctly set the default settape variable in amrecover
to /dev/st0?
My amrecover tells me:
Usage: amrecover [[-C] <config>] [-s <index-server>] [-t <tape-server>] [-d
<tape-device>]
So it would work with:
amrecover -d /dev/st0 ....
If you roll your own binaries, you could configure your sources with
configure --with-tape-device= /dev/st0
--
best regards,
Stefan
Stefan G. Weichinger
mailto:monitor AT oops.co DOT at
|
|
|