Hi

--
Martin Hepworth
Senior Systems Administrator
Solid State Logic Ltd
+44 (0)1865 842300



Toralf Lund wrote:

I've mentioned this earlier, but not a lot came out of it:

I've been getting a lot of

*** A TAPE ERROR OCCURRED: [[writing file: I/O error]].

lately. This does not, however, happen all the time, and not for specific tapes, either. Also, I can't find any error messages related to the tape device in the system log etc., and I've tested the unit quite a bit, and based on that, I don't think the problem is really the *write*, but is rather related to the holding disk image read. I can't figure out how exactly, though.

How do I go about finding out what exactly is wrong? Also, who wrote the above mentioned error message? I'm a bit annoyed with that person now, I must say. Why? Well, for leaving out the file name from a file related error message, of course. [ Some serious flaming omitted at this point... ]

Amanda version
(brought to you by Amanda version 2.4.4p1)

Before that I used one of the 2.4.4 snapshots, and before that again, 2.4.4. I got the same problem with the snapshot release, but not 2.4.4 itself, I believe (so perhaps I'll downgrade...)

**********************************************************************
This email and any files transmitted with it are confidential and
intended solely for the use of the individual or entity to whom they
are addressed. If you have received this email in error please notify
the system manager.

This footnote also confirms that this email message has been swept by
MIMEsweeper for the presence of computer viruses.

www.mimesweeper.com
**********************************************************************