On Tue, 4 Mar 2003 at 8:52am, Jamie Bowden wrote
> complete core). I see the AMANDA_TMPDIR and AMANDA_DBGDIR listed, but I
> don't see anywhere to change those in amanda.conf. If someone else has
> compiled amanda in this environment and run into this, I'd appreciate a
> clue.
You can specify those at ./configure time.
> It appears to run fine until it runs out of tape (for some reason, it's
> running out of tape on a DLT7000 dumping to 'tapedev
> "/dev/rmt/tps2d7nrnsv.7000c"' (no rewind, non byte swapped, variable
> block, DLT 7000, hardware compress) at around 30GB. And then it dumps
> core. 2.4.1p1 got variable lengths out of that same device, with the
> average being about 50GB, but when it ran out (rare occurance), it would
> spool remaining dumps to holding disk and exit gracefully.
This is a known issue with 2.4.3, and it's been fixed in 2.4.4.
--
Joshua Baker-LePain
Department of Biomedical Engineering
Duke University
|