I have changerdev setup and working but I have 2 DLT8000 drives.
What I am wondering is how do I tell amanda about 2 drives?
Right now I have this in the amanda.conf:

tapedev "/dev/st/nh0c0t1l0"     # the no-rewind tape device to be used

But that is only one of the two.  Should this be something different?
My 2 drives are:
/dev/st/nh0c0t1l0
/dev/st/nh0c0t2l0  

I think I may be getting close to a working config.

Thanks all.

Mark