Re: [ADSM-L] getting front end capacity for licensing

Subject:

From:

Jacques Van Den Ende <jacques_van_den_ende AT BE.IBM DOT COM>

To:

ADSM-L AT VM.MARIST DOT EDU

Date:

Mon, 13 Nov 2017 20:17:31 +0100

Hi,

Go to report section and run the License Validation.
Hope this will help

Regards,

Jacques Van den Ende
Advisory IT Specialist


Phone: 352-360-385 x322 \| Mobile: 32-475 29 43 87 E-mail: jacques_van_den_ende AT be.ibm DOT com	89c rue pafenbruch Capellen, 8308 Luxembourg

From: "Lee, Gary" <glee AT BSU DOT EDU>
To: ADSM-L AT VM.MARIST DOT EDU
Date: 13/11/2017 19:19
Subject: [ADSM-L] getting front end capacity for licensing
Sent by: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>

We have been asked for front end capacity numbers for our tsm installation. We have three servers v 7.1.7.1 running on RHEL 6.9. Clients range from 6.0 on up. Checked the fecapacity field, and those numbers look like pure junk. Tried using the actual_size field in filespaces table, but this is usually empty. Is there a good way to get these numbers? Supposedly they exist in the ops center, but haven't found them there either. Any help appreciated.

IBM Luxembourg S.à r.l.
Siège social: 89C rue Pafebruch, L-8308 Capellen, Luxembourg
TVA LU 19966740
Capital social: EUR 4.000.100
R.C.S. Luxembourg B 98.800

<Prev in Thread]

Current Thread

[Next in Thread>

Previous by Date:

[ADSM-L] getting front end capacity for licensing, Lee, Gary

Next by Date:

Re: [ADSM-L] getting front end capacity for licensing, Giacomo Testa

Previous by Thread:

[ADSM-L] getting front end capacity for licensing, Lee, Gary

Next by Thread:

Re: [ADSM-L] getting front end capacity for licensing, Giacomo Testa

Indexes:

[Date] [Thread] [Top] [All Lists]