[ADSM-L] Question on Collocation
2017-11-03 17:11:56
I use collocation and I have a node where the System Admin has requested that
his data from a particular node be isolated on tapes by itself. I created a
collocation group and have associated this one node with the new group. This
node had previously been backing up to a different collocation group. I created
a new Policy Domain and associated the node with it as well. This policy domain
is set to send the data direct to tape instead of going to our diskpool. I also
modified the settings on the server to allow this system to have 2 mount points.
I had the SA launch a "full" manual backup from the GUI - using the "Always
Backup" option. Here are the problems I am seeing.
1. I can see that the system state data when to a tape that was already
used by other nodes (which tells me the collocation is not working)
2. It only mounted 1 tape in a drive while performing the backup
3. The metrics at the end showed that it inspected 283 GB of data and
only transferred 175 GB which means it did not actually perform a full backup.
Any ideas to help get a FULL backup of this data alone on a single 1 or 2 tapes
and ideally using multiple tape drives to speed things up? (for backup and
restore)
Thanks!
Jennifer
|
ADSM.ORG Privacy and Data Security by KimLaw, PLLC
|