[ADSM-L] SET REPLRECOVERDAMAGED question
2015-03-04 00:55:41
Hi to all
In TSM Version 7.1.1+ there is a new feature called SET REPLRECOVERDAMAGED
To use it need to be ON with the command: SET REPLRECOVERDAMAGED ON
Here the help below but don’t understand what is the default YES or NO ?
During a replicate node.
RECOVERDamaged--=--+-Yes--
+-No---
+-Only-
RECOVERDamaged
Specifies whether a recovery process is started on a target replication
server after the node replication process is completed.
This parameter is optional, and it overrides any value that you specified
for the RECOVERDamaged parameter when you defined or updated a node. You can
specify one of the following values:
Yes
Specifies that a replication process is started to recover damaged
files, but only if the setting for the REPLRECOVERDAMAGED system
parameter is ON. If the setting is OFF, damaged files are not recovered.
No
Specifies that damaged files are not recovered.
Only
Specifies that a replication process is started for the sole purpose of
recovering damaged files, but only if the setting for
the REPLRECOVERDAMAGED system parameter is ON. If the setting is
OFF, damaged files are not recovered, and you receive a notification that
recovery was not started.
Best Regards
Robert Ouzen
Haifa University
Israel
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- [ADSM-L] SET REPLRECOVERDAMAGED question,
Robert Ouzen <=
|
|
|