I've got these that I'll be putting in my daily report once we get onto 7.1.1:
select node_name from nodes where repl_state<>'ENABLED'
select node_name,fsname,state,phase,comp_state,comp_reason,end_time from
replicationview where comp_state<>'COMPLETE'
-
Cameron Hanover
chanover AT umich DOT edu
"They that can give up essential liberty to obtain a little temporary safety
deserve neither liberty nor safety."
--Benjamin Franklin
On Nov 10, 2014, at 2:27 PM, Plair, Ricky <rplair AT HEALTHPLAN DOT COM> wrote:
> Can someone tell me if there is a TSM command/script out there that will show
> you which nodes are replicating and which ones are not replicating.
>
> I appreciate your time.
>
> Ricky M. Plair
> Storage Engineer
> HealthPlan Services
> Office: 813 289 1000 Ext 2273
> Mobile: 757 232 7258
>
>
> _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
> CONFIDENTIALITY NOTICE: This email message, including any attachments, is for
> the sole use of the intended recipient(s) and may contain confidential and
> privileged information and/or Protected Health Information (PHI) subject to
> protection under the law, including the Health Insurance Portability and
> Accountability Act of 1996, as amended (HIPAA). If you are not the intended
> recipient or the person responsible for delivering the email to the intended
> recipient, be advised that you have received this email in error and that any
> use, disclosure, distribution, forwarding, printing, or copying of this email
> is strictly prohibited. If you have received this email in error, please
> notify the sender immediately and destroy all copies of the original message.
|