Re: [ADSM-L] Spectra T-Finity/TS1140/TSM 6.3/RHEL6
2014-09-21 20:07:41
On 11/09/14 09:01, Tom Tann{s wrote:
Hi!
Anyone using this combination of library/drives/OS?
I try using the tsm-device-driver to control the library, and lin_tape to
control the drives.
The library and the drives connect OK and seem to work fine by themselves.
Defining paths to the drives in the library fails, because the library use only
the first 10 digits in the drive S/N, while lin_tape use all 12. So there is a
mismatch, and the drive is not found in the library.
PMR's have been opened against IBM and Spectra..
Has anyone got a similar configuration and made i work?
I have a similar setup different library vendor but...
Just be careful with compatible versions, The compatible matrix gets
very complicated. Last I heard you had to use RH6.4...
Grant
|
|
|