Re: [ADSM-L] upgrae from 5.5.4 to 6.2.4
2013-02-27 09:42:50
We did an upgrade from 5.4 to 6.2.
I used a copy (SAN trick) for the source of the upgrade. I do not think the
5.5 to 6.2 upgrade changed the copy, I did not check, but I did not see any
writes to the disks. The extract was written to a new disk. We created a new
devclass (file) to write the data to.
Our about 200GB DB took about 3 hours to extract, the insert to 6.2 took
10+hours. This was done on a P6.
We did 3 practice upgrades for each server. Only 1 upgrade test failed because
we did not get a clean copy.
You might consider 6.2.5 as your target.
Good Luck.
Andy Huebner
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Lee, Gary
Sent: Wednesday, February 27, 2013 8:20 AM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: [ADSM-L] upgrae from 5.5.4 to 6.2.4
I want to do a couple of practice upgrades of our tsm server v5.5.4 to a
different box running v6.2.4.
Reading the upgrade guide, I have to do the
Dsmupgr prepared
Then a
Dsmupgrd extractdb
I have not yet determined whether these will render the 5.5.4 server unusable?
Has anyone out there done this and if so, what should I expect?
Gary Lee
Senior System Programmer
Ball State University
phone: 765-285-1310
|
|
|