ADSM-L

Re: [ADSM-L] we need more tapes in the next pool after replacing a primary disk pool with a primary sequential pool

2010-12-06 07:57:11
Subject: Re: [ADSM-L] we need more tapes in the next pool after replacing a primary disk pool with a primary sequential pool
From: "Lee, Gary D." <GLEE AT BSU DOT EDU>
To: ADSM-L AT VM.MARIST DOT EDU
Date: Mon, 6 Dec 2010 07:56:28 -0500
Give the "move data" command a try.
This will move data from one volume in a sequencial pool to another.
 


Gary Lee
Senior System Programmer
Ball State University
phone: 765-285-1310

 
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of 
TSM
Sent: Monday, December 06, 2010 4:16 AM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: [ADSM-L] we need more tapes in the next pool after replacing a primary 
disk pool with a primary sequential pool

Hello,

We replaced a primary disk pool on fc disks with a bigger primary
sequential pool on sata disks.
The primary sequential pool on disk is migrated to a primary pool an tape
using 3 processes.
Both pools are collocated by node.
Now we need more tapes in the next pool because the migration wrote some
tapes for the same node in parallel and for the same node there are more
tapes in filling state.

Any solution for reducing the tapes in filling state?

with best regards
Andreas.