Re: [ADSM-L] DSMADMC running from Target server?
2010-02-01 09:48:20
Eric,
The "-server" option is just a pointer to a TSM stanza instance in your DSM.SYS
configuration file.
It is there that you will have to provide the "TCPSERVERADRESS" for your target
server ...
Cheers.
Arnaud
******************************************************************************
Corporate IT Systems & Datacenter Responsible
Panalpina Management Ltd., Basle, Switzerland,
CIT Department Viadukstrasse 42, P.O. Box 4002 Basel/CH
Phone: +41 (61) 226 11 11, FAX: +41 (61) 226 17 01
Direct: +41 (61) 226 19 78
e-mail: arnaud.brion AT panalpina DOT com
******************************************************************************
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Eric Vaughn
Sent: lundi 1 février 2010 15:39
To: ADSM-L AT VM.MARIST DOT EDU
Subject: DSMADMC running from Target server?
Could someone tell me if I am using incorrect syntax. I am trying to run
dsmadmc from my target server in order to query some volumes that may have
potential problems. I was getting the error ANS8019E before I added the (-) in
front of id and password. After adding (-) I dont get an error, but it does not
establish a connection with the correct server. It establishes a connection
with my source server. I am using the following and running from the baclient
directory.
dsmadmc -server=10.10.1.xxx -id=admin -password=admin
10.10.1.xxx is my target server. The command is being ran from this server as
well.
My output establishes a connection with the source. Anyone have any thoughts or
ideas as to what I could be doing wrong?
Eric Vaughn
Technical Administrator
Stevenson University
Office (443)334-2301
evaughn AT stevenson DOT edu
|
|
|