Re: [ADSM-L] Backup files to empty tape
2009-04-01 14:53:34
I assume you are using scratch tapes in your library for the pool where this
data is heading. By default, TSM will choose one of the filling scratch tapes
first. To make sure it uses a brand new tape, set all the filling tapes in
that pool in that library to ReadOnly. Then start the backup to that pool.
TSM will be forced to take another tape from scratch. Note the volser of the
tape being used. When the backup is done, check that tape out and set the
readonly tapes back to readwrite.
There are variations on the theme but this will work. Make sure nothing else
is going on during this or you might get other data on that tape.
Thanks,
Kelly Lipp
CTO
STORServer, Inc.
485-B Elkton Drive
Colorado Springs, CO 80907
719-266-8777 x7105
www.storserver.com
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Mario Behring
Sent: Wednesday, April 01, 2009 12:23 PM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: [ADSM-L] Backup files to empty tape
Hi list,
I have to backup some files from a TSM node to an empty tape and send this tape
away (check out from the library). What is the best approach to perform this
task?
Thanks
Mario
|
|
|